Location
Balgowlah, NSW
Site
Residential basement car park
Equipment
Molnar car stackers
Parking
Two cars per space
About the project.
The residential building at 11 Lewis St, Balgowlah, on Sydney’s Northern Beaches, has a row of Molnar car stackers in its basement car park.
Each stacker lifts one car on a platform so a second car can park in the space underneath, fitting two cars into each parking space. The stackers stand side by side along the car park wall.
Car stackers are dependent parking: the space underneath must be empty before the platform above can be raised or lowered.
Photos.
3 photos. Select one to see it larger and step through the set.
Car stackers in our range.
Parking systems that fit two or three cars into the space of one.
LASER-2.2 CP
A hydraulic two-post car stacker that doubles parking in the same space. It can stand alone or run as a row of units sharing columns.
Suited to car repair workshops, dealerships, private parking, car rental areas and valet parking.
Key specifications
| Lifting Capacity | 3,000 kg |
| Clearance Below | 2,140 mm |
| Overall Height | 3,510 mm |
| Platform Length | 4,175 mm |
| Platform Width | 2,244 mm |
| Lifting Time | 50 seconds |
| Warranty | 3 years (maintenance contract required to validate) |
LASER-4.3 CP
A three-car stacking system that triples parking capacity, for commercial buildings, apartment complexes and other space-constrained car parks.
Key specifications
| Lifting Capacity | 3,000 kg per platform |
| Platform Width | 1,890 mm |
| Platform Length | 4,900 mm |
| Overall Height | 4,112 mm |
| Lifting Time | 65 seconds |
| Concrete Requirement | 150 mm reinforced concrete, 25 MPa |
| Warranty | 3 years (maintenance contract required to validate) |
Installed and looked after by Molnar.
Molnar Services install, service, inspect and repair vehicle hoists across Australia.
01
Installation
Delivery and installation for all our hoists, by trained and qualified installers, with operating and maintenance manuals, a hoist owner’s logbook and a follow-up visit at six weeks.
02
Routine servicing
Managed maintenance programs with scheduled service reminders, genuine parts and technicians working to Australian standards and regulations.
03
Safety inspections
Inspections against Australian standards, with compliant record keeping and logbook maintenance, so your workshop meets its obligations under AS/NZS 2550.9.
04
Breakdown repairs
Agreed response times, genuine Molnar parts and support from a national network of experienced hoist technicians.
Questions.
Something else you need to know? Ask our team.
Can the lower car drive out while the upper car is parked?
Yes. The lower car can leave at any time, but the platform above can only be lowered once the space underneath is empty.
Do car stackers need a pit?
No. The LASER-2.2 CP installs above ground with no pit.
How heavy a car can they lift?
Up to 3,000 kg on each platform.
What power and floor do they need?
415 V three-phase power at 10 amps, or an optional single-phase supply at 16 amps. The LASER-4.3 CP needs a 150 mm reinforced concrete slab of 25 MPa.
What warranty do they come with?
Three years, with a maintenance contract to keep the warranty valid. Spare parts are supported by a national service network.
